E6581386
F-64
6
6.30.2 Setting of optional meter outputs
~ , ~ : Meter output settings
For details, refer to Instruction Manual (E6581341) specified in Section 6.36.
6.30.3 Calibration of analog outputs
: FM voltage/current output switching
, : FM output gradient characteristic and bias adjustment
, : AM output gradient characteristic and bias adjustment
Function
Output signals from FM/AM terminals are analog voltage signals. Their standard setting range is from 0 to
10Vdc.
The output current from terminal FM can be changed to 0 to 20mAdc (or 4 to 20mAdc) by changing the settings
of terminal SW2 and a parameter.
[Parameter setting]
Title Function Adjustment range Default setting
FM voltage/current output
switching
: Voltage 0~10V output
: Current 0~20mA output
FM output gradient
characteristic
: Negative gradient
(descending)
: Positive gradient
(ascending)
FM bias adjustment -～. %
AM output gradient
characteristic
: Negative gradient
(descending)
: Positive gradient
(ascending)
AM bias adjustment -～. %
Note: To switch to 0-20mAdc (4-20mAdc), set to .
FM terminals setting example
,
=
=
(%)
,
=
=
(%)
20
0
0
Internal calculated value
100%
0
Internal calculated value
100%
4
Output current
(mA)
20
Output current
(mA)
=
=
=
(%)
=
=
=
(%)
20
0
0
Internal calculated value
100%
0 100%
: Large gain
:Small gain
4
Output current
(mA)
20
Output current
(mA
)
Internal calculated value
SW2: 0-10V/0-20mA side
SW2: 0-10V/0-20mA side
SW2: 0-10V/0-20mA side
SW2: 0-10V/0-20mA side
The analog output inclination can be adjusted using the parameter
For code data 50 to 64, negative inclination is invalid.
To Next Page
Loading...
Need help?
General
