E6581611
E-18
5
3) Using other speed commands with preset-speed command
Command mode
selection
0: Terminal block
1: Panel keypad (including extension panel)
2: RS485 communication
3: CANopen communication
4: Communication option
Frequency setting
mode selection
0:Setting dial 1 (including extension
panel) (save even if power is off)
1: Terminal VIA
2: Terminal VIB
3: Setting dial 2 (including extension
panel) (press in center to save)4:
RS485 communication
5: UP/DOWN from external logic input
6: CANopen communication
7: Communication option
8: Terminal VIC
9, 10: -
11: Pulse train input
12, 13: -
14: sr0
0:Setting dial 1 (including extension panel)
(save even if power is off)
1: Terminal VIA
2: Terminal VIB
3: Setting dial 2 (including extension panel)
(press in center to save)
4: RS485 communication
5: UP/DOWN from external logic input
6: CANopen communication
7: Communication option
8: Terminal VIC
9, 10: -
11: Pulse train input
12, 13: -
14: sr0
Preset-
speed
command
Active Preset-speed command valid Note)
Inactive Command set with fmod is valid
Note) The preset-speed command is always given priority when other speed commands are input at the same time.
An example of three-speed operation with the default settings is shown below.
(Frequency settings are required for to .)
F-CC
S1(SS1)-CC
S2(SS2)-CC
ON
OFF
ON
OFF
ON
OFF
Output frequency
Time
0
(The inverter doesn't accept
Preset-speed command.)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
Need help?
General