E6581611
D-4
4
Standard setting mode : The mode changes to the Standard setting mode when
the EASY key is pressed and "std" is displayed.
Both basic and extended all parameters are displayed.
Basic parameters : This parameter is a basic parameter for the
operation of the inverter.
Refer to chapter 5 for details.
Refer to section 11.2 for parameter tables.
Extended parameters : The parameters for detailed and special
setting.
Refer to chapter 6 for details.
Refer to section 11.3 for parameter tables.
Note) There are the parameters that cannot be changed during inverter running for reasons of safety. Refer to section 11.9.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net