Toyota 4A-FE Repair Manual

\1-4
4A-FE Engine
INTRODUCTION - Identification Information, General Repair Instructions
4A-GE Engine
INOl 16 IN0035
IDENTIFICATION INFORMATION
ENGINE SERIAL NUMBER
The engine serial number is stamped on the left side of the
cylinder block.
GENE_RAL REPAIR INSTRUCTIONS
1. Use fender, seat and floor covers to keep the vehicle clean
and prevent damage.
2. During disassembly, keep parts in order to facilitate
reassembly.
3. Observe the following:
{a) Before performing electrical work, disconnect the
negative cable
from the battery terminal.
(b) If it is necessary to disconnect the battery for inspec-
tion or repair, always disconnect the cable from the
negative
(-) terminal which is grounded to the vehi-
cle body.
(c) To prevent damage to the battery terminal post,
loosen
the terminal nut and raise the cable straight up
without twisting or prying it.
(d) Clean the battery terminal posts and cable terminals
with a shop rag. Do not scrape them with a file or
other abrasive object.
(e) Install the cable terminal to the battery post with the
nut loose, and tighten the nut after installation. Do
not use a hammer to tap the terminal onto the post.
(f)
Be sure the cover for the positive(+) terminal is pro-
perly in place.
4. Check hose and wiring connectors to make sure
that they
are secure and correct.
5. Non-reusable parts
(a) Always replace cotter pins gaskets, 0-rings, oil seals,
etc.
with new ones.
(b) Non-reusable parts are indicated in the component
illustrations by the symbol "+".

Toyota 4A-FE Specifications

General

Brand	Toyota
Model	4A-FE
Category	Engine
Language	English