TP-Link TL-SF1005D User Manual

5
Appendix B: Troubleshooting
1. The Power LED is not lit
Check to see if the power cord is connected to the Switch properly, and make sure the
power source is ON.
2. The Link/Act LED is not lit when a device is connected to the corresponding port
Check to see if the cable connectors are firmly plugged into the Switch and the device, and
verify the connected device is turned on and working well. Make sure the cable is not longer
than 100 meters (328 feet).

TP-Link TL-SF1005D Specifications

General

MAC address table	1000 entries
Store-and-forward	Yes
Maximum data transfer rate	0.1 Gbit/s
Supported data transfer rates	10/100 Mbps
10G support	No
Networking standards	IEEE 802.3u, IEEE 802.3x
Copper ethernet cabling technology	100BASE-TX, 10BASE-T
Switch type	Unmanaged
Switch layer	-
Supported network protocols	CSMA/CD, TCP/IP
Power connector	DC-in jack
Basic switching RJ-45 Ethernet ports type	Fast Ethernet (10/100)
Basic switching RJ-45 Ethernet ports quantity	5
Certification	FCC, CE, RoHS
Product color	White
Heat dissipation	6.38 BTU/h
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Power source	DC
Input current	0.6 A
Input voltage	5 V
Power consumption (max)	1.48 W
Package depth	91 mm
Package width	108 mm
Package height	85 mm
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	69.5 mm
Width	103.5 mm
Height	22 mm