14
Installation (Continued)
Table 3-1
Typical Unit Weights & Point Loading Data
Operating Unit Weight on Isolator @ Mounting Location
Unit Weight 1 2 3 4 5 6
Size AL CU AL CU AL CU AL CU AL CU AL CU AL CU
C20 1146 1343 320 371 326 365 248 306 252 301
C25 1190 1393 329 378 337 381 259 315 265 319
C30 1302 1594 353 414 371 444 282 355 296 381
C40 2048 2379 363 406 347 392 349 404 334 389 335 401 320 387
C50 2280 2672 407 464 392 449 387 453 373 438 367 441 354 427
C60 2465 3036 433 515 420 505 417 511 405 501 401 507 389 497
Notes:
1. Mountin
locations correlate with those shown in point loadin
illustration.
Figure 3-3
Rigging and Center-of-Gravity Data
Location of Center of
Shipping Gravity =
Unit Weight X Z
Size (Max. Lbs) In mm In mm
C20 1348 41 1026 30 754
C25 1394 41 1031 30 762
C30 1585 41 1046 31 790
C40 2366 44 1115 43 1097
C50 2664 56 1428 43 1100
C60 3010 57 1440 44 1107
LIFTING AND MOVING INSTRUCTIONS!
DO NOT USE CABLES (CHAINS OR SLINGS) EXCEPT AS
SHOWN. OTHER LIFTING ARRANGEMENTS MAY CAUSE
EQUIPMENT DAMAGE OR SERIOUS PERSONAL INJURY.
EACH OF THE CABLES (CHAINS OR SLINGS) USED TO LIFT
UNIT MUST BE CAPABLE OF SUPPORTING THE ENTIRE
WEIGHT OF THE UNIT.
LIFTING CHAINS (CABLES OR SLINGS) MAY NOT BE THE
SAME LENGTH. ADJUST AS NECESSARY FOR EVEN
LEVEL LIFT.
USE SPREADER BARS AS SHOWN IN DIAGRAM. REFER
TO INSTALLATION MANUAL OR NAMEPLATE FOR UNIT
WEIGHT. REFER TO INSTALLATION INSTRUCTIONS
LOCATED INSIDE CONTROL PANEL FOR FURTHER
RIGGING INFORMATION.
To Next Page
Loading...
Need help?
General