RT-SVX36G-EN 61
Installation
Flue Assembly Installation
1. Locate the flue assembly and the extension (refer to Figure 28 for extension usage) in the ship
with section of the unit.
2. Install the flue extension onto the flue assembly as shown in Figure 28.
3. Slide the pipe clamp onto the heater flue tube located inside the heater compartment.
4. Insert the tube on the flue assembly into the hole located in the vertical support for the heat
section.
5. Butt both flue tube sections together and center the pipe clamp over joint.
6. Using the pre-punch holes in the flue assembly, extension, and the vertical support, install the
appropriate number of mounting brackets. Refer to Figure 28 for details.
Figure 27. Modulating 500 - 1000 MBH
Burner NozzleBurner Nozzle
Pilot Shutoff ValvePilot Shutoff Valve
Pilot Solenoid ValvePilot Solenoid Valve
Pilot Regulator ValvePilot Regulator Valve
Pilot Shutoff ValvePilot Shutoff Valve
Modulating Gas ValveModulating Gas Valve
Shutoff ValveShutoff Valve
To Next Page
Loading...
Need help?
General
