EasyManuals Logo
Home>Trane>Furnace>S8X1 Series

Trane S8X1 Series User Manual

Trane S8X1 Series
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
18-CE04D1-1B-EN
WWaarrnniinngg:: TThheessee ffuurrnnaacceess aarree nnoott aapppprroovveedd oorr
iinntteennddeedd ffoorr iinnssttaallllaattiioonn iinn mmaannuuffaaccttuurreedd ((mmoobbiillee))
hhoouussiinngg,, ttrraaiilleerrss,, oorr rreeccrreeaattiioonnaall vveehhiicclleess..
Locations and Clearances
The location of the Furnace is normally selected by the
architect, the builder, or the installer. However, before
the Furnace is moved into place, be sure to consider
the following requirements:
1. Is the location selected as near the chimney or vent
and as centralized for heat distribution as practical?
2. Do all clearances between the Furnace and
enclosure equal or exceed the minimums stated in
Clearance Table below?
Minimum clearance to combustible materials
3. Is there sufficient space for servicing the Furnace
and other equipment? A minimum of 24 inches
front accessibility to the Furnace must be provided.
Any access door or panel must permit removal of
the largest component.
4. Are there at least 3 inches of clearance between the
Furnace combustion air openings in the front panel
and any closed panel or door provided?
5. Are the ventilation and combustion air openings
large enough and will they remain unobstructed? If
outside air is used, are the openings set 12" above
the highest snow accumulation level?
6. Allow sufficient height in supply plenum above the
Furnace to provide for cooling coil installation, if
the cooling coil is not installed at the time of this
Furnace installation.
7. The Furnace shall be installed so electrical
components are protected from water.
8. If the Furnace is installed in a garage, it must be
installed so that the burners, and the ignition
source are located not less than 18 inches above the
floor and the Furnace must be located or protected
to avoid physical damage from vehicles.
9. The gas furnace must not be located where
excessive exposure to contaminated combustion
air will result in safety and performance related
problems. Avoid the following known
contaminants:
a. Permanent wave solutions
b. Chlorinated waxes and cleaners
c. Chlorine based swimming pool chemicals
d. Water softening chemicals
e. De-icing salts or chemicals
f. Carbon tetrachloride
FFuurrnnaaccee IInnssttaallllaattiioonn GGuuiiddeelliinneess

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trane S8X1 Series and is the answer not in the manual?

Trane S8X1 Series Specifications

General IconGeneral
BrandTrane
ModelS8X1 Series
CategoryFurnace
LanguageEnglish

Related product manuals