STATUS MENU
ACTIVE ERRORS
Example
Gas Heat
Example
Tap 5
Example
Pressure Switch Error
LAST 6 FAULTS
Example
Pressure Switch Error
Example
Open Limit Switch Error
Control Release #
Example
So!ware Version #
Cooing Off Delay
Example
seconds
Outdoor Stages
Heat Off Delay
Example
seconds
Inter-Stage Delay
Example
seconds
Con$nuous Fan Tap
Example
Tap #
Compressor Opera$on
Speed Tap
Example
Tap #
Example
1
st
Stage Tap #
Hea$ng Speed Tap
Example
Single Stage
Example
2 stage 1 compressor
Run Test Mode
LED Orienta$on
S8X1 Control System Menu Single Stage OD
SETTING UP YOUR SYSTEM:
To change any factory default value, first remove any “call” from the
furnace and allow all fan off delays to finish. (1 DL should be seen on the
display).
Scroll to the selected Menu item by momentarily depressing the “MENU”
key and then depress the “OPTION” key to the desired se&ng. Then
momentarily depress the “MENU” key again to save the change.
CLEARING THE LAST 6 FAULTS:
To clear the stored faults, scroll to the last 6 faults menu, enter the menu
by scrolling to the right and hold the “Op$on” key for at least 5 seconds.
Release and a set of 3 dashes will be seen 3 $mes. This confirms the
faults have been cleared.
SELECTING COOLING / HP FAN SPEEDS for 1-1 ODU:
Scroll to the COP menu and momentarily push the OPTION key. Tap 7 is the default
se&ng for all models. When selec$on is made, momentarily push the MENU key to
save.
Default Airflow Taps
Gas Heat = Tap 5
ODU Menu 1-1
Cooling / HP = Tap 7
SELECTING GAS HEATING FAN SPEEDS:
Scroll to the HTP menu and momentarily push the OPTION key. Tap #5 is the default se&ng for all models. When
selec$on is made, momentarily push the MENU key to save.
NOTE: Tap 9 is not available for gas hea$ng.
To Next Page
Loading...
Need help?
General