BAS-SVX36C-EN 35
Operation
Changing the Fan Mode
Note: If you are unable to see the fan mode, check the system type setting in the installation
configuration options to make sure that it is specified as a system with a fan.
There are two fan modes. Each are indicated by an icon on the display:
T
o change the fan mode:
1. Press > > .The current mode flashes.
2. Press or to change the mode.The selected mode flashes.
Note: If
you are unable to change the mode and flashes, the mode is locked. See “Locking
or Unlocking Modes,” p. 40.
3. Tap or wait 5 sec to save and exit.
Programmable Thermostats
Programmable thermostats contain all of the functionality of the non-programmable thermostats,
but they also keep track of the date, day of week, and time of day for scheduling purposes.
Programming
This section describes how to program the thermostat after it has been installed and configured.
Setting the Time
The time must be set in the thermostat to ensure operation of the schedule.
Note: The
date is set during configuration and the day of the week is calculated automatically
according to the date.
To set the time:
1. Press > > > > > .The hour flashes to indicate that it can be changed.
Note: The thermostat automatically returns to normal operating mode if no buttons are
pressed for 10 sec.
2. Make changes to the hour and minute, as needed:
• P
ress or to switch between hours and minutes.The changeable option flashes to
indicate that it can be changed.
• Press or to change the value of the option.
3. Press and hold for 2 sec or wait 10 sec to apply the change and exit.
Auto mode turns the fan on and off as needed according to equipment configuration.
On runs the fan continuously.
Mo
AM
To Next Page
Loading...
Need help?
General
