19
Operation
2. Switch the Inverter’s ON/OFF switch to the ON (I) position. If you
are using the included PINVRM remote panel, set the switch to
the REMOTE (II) position and press the ON button on the remote
panel.
3. The green LED indicator will illuminate on the unit or remote panel
(If installed), indicating the Inverter is receiving power.
4. Switch the Inverter’s ON/OFF/REMOTE switch to the OFF (O)
position. The green LED may flash briefly and/or the internal
speaker may beep briefly. This is normal.
5. Make sure the device(s) to be operated is turned OFF.
6. Plug the device(s) into the Inverter’s AC outlet(s).
7. Switch the inverter’s ON/OFF/REMOTE switch to the ON (I) or
REMOTE (II) positions. If using the remote position, connect the
PINVRM cable connector to the RJ11 jack on the unit labeled
REMOTE and press the ON/OFF momentary switch to power the
inverter.
8. Turn the device(s) on.
9. To disconnect, reverse the above procedure.
USB Charging Operation
The USB charging port is ON when the Inverter is connected to a 12V
DC power source. Connect your device(s) to this port for USB charging
up to 2.0A. Remove your device(s) from the USB port when it has
finished charging to reduce battery drain or start vehicle.
19-04-283-9338A1.indb 19 5/2/2019 3:49:34 PM
To Next Page
Loading...
Need help?
General
