75
Maintenance and Adjustment
To check the oil level in the final drive unit,
remove the filler/level plug. Fill with
Mobilube 1 SHC 75W-90 fully synthetic
hypoid oil (or equivalent) until the level of oil
inside the unit is level with the bottom of the
filler. Refit the plug and tighten to 60 Nm.
Tyres
1. Wheel marking
This motorcycle is equipped with tubeless
tyres, valves and wheel rims. Use only tyres
marked 'TUBELESS' and tubeless valves on
rims marked 'FOR TUBELESS'.
Tyre Inflation Pressures
Correct inflation pressure will provide
maximum stability, rider comfort and tyre life.
Always check tyre pressures before riding
when the tyres are cold. Check tyre
pressures daily and adjust if necessary. See
the Specification section for details of the
correct inflation pressures - see 'Tyres:
Pressures' on page 97.
Warning
Under no circumstances should the final
drive unit be disassembled. Failure to
observe the above warning could lead to a
malfunction of the final drive unit causing
lock-up of the rear wheel leading to loss of
motorcycle control and an accident.
cenl
1
To Next Page
Loading...
Need help?
General
