Section 3: Assembly
2. Insert carriage boHt through Heft side hoHefrom outside
of unit and attach a pHastic knob from inside of unit
(viewing from rear of unit).Tighten by hand (Figure 2).
4. PHaceaccessory tray over holies on handHe (viewing
from front of unit). Push the tree chips into the holies
untiHthey sit fiat against the accessory tray (Figure 3).
3.
Insert"L" boHtsthrough holieson right side of handHe
(viewing from rear of unit). HoHdboHtsin pHaceand
attach pHasticknobs from inside of handHe(Figure 2).
Tighten by hand.
j_,/"
Acid Engine Oil and Fuel
* PHace pressure washer on a level surface.
° Refer to engine operator's manuaH and follow oiH and fuel
recommendations and instructions.
• Refer _:oengine manual for oil and fuel fill information.
• Damage to equipment resuh:ing from failure _:ofollow this
instrud:ion will void warrant:y,
NOTE_ Check oiH often during engine break-in. Refer to
engine operator's manual for recommendations,
0
To Next Page
Loading...
Need help?
General
