Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
Adjustments
Shift Cable
If the full range of speeds (forward and reverse) cannot be
achieved adjust the shift cable as follows:
Loosen the hex nut on the shift cable index bracket. See 2.
3.
Retighten the hex nut.
Auger Control
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.
Track Tension
Loosen the hex nuts on the front track idler wheels on each
side of the snow thrower.
Tighten the flange lock nut on the front of the track side 2.
tightens the tracks.
Tighten the hex nuts on the front track idler wheels.3.
Front Track
17se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s
To Next Page
Loading...
Need help?
General
