What to do if my TSC Barcode Reader is out of label?
If your TSC Barcode Reader is out of labels, load a new roll of labels following the media loading instructions, then press the FEED button to resume printing.
How to improve print quality on my TSC TDP-225?
If your TSC Barcode Reader is producing poor print quality, ensure the top cover is completely closed and latched on both sides. Verify that the correct 24V DC power supply is connected. Reload the supply correctly. Clean the print head if dust or adhesives have accumulated. Adjust the print density and speed settings. Run a self-test to check the print head test pattern for any missing dots.
How to fix 'Out of Mem' error on my TSC Barcode Reader?
If your TSC Barcode Reader displays 'Out of Mem', delete unused files from the FLASH/DRAM or MicroSD card to free up space.
How do I fix a paper jam on my TSC TDP-225 Barcode Reader?
If your TSC Barcode Reader displays 'Paper Jam', calibrate the gap/black mark sensor. Ensure the label size is set correctly. Remove any jammed labels from inside the printer mechanism.
Why is my TSC Label Maker not printing?
If your TSC Label Maker isn't printing, several factors could be the cause. Ensure the interface cable is securely connected. If using a serial port, the cable's pin configuration must be pin-to-pin; if it is not, replace the cable. Also, verify that the serial port settings are consistent between your host and the printer, and that the correct printer port is selected in the Windows driver. For Ethernet connections, confirm that the IP address, subnet mask, and gateway are properly configured.
What to do when my TSC TDP-225 says 'No Paper'?
If your TSC Barcode Reader displays 'No Paper', supply a new label roll. If that doesn't work, refer to the user’s manual for steps to reinstall the label roll correctly. If problems persist, calibrate the gap/black mark sensor.
How to fix a TSC TDP-225 Barcode Reader with no response?
If your TSC Barcode Reader shows 'No Response', try the following: * First, ensure the power switch is turned on. * Check that the green LED on the power supply is lit; if not, the power supply may be broken. * Verify that both power connections—from the cord to the supply and from the supply to the printer—are securely connected.
Why is my TSC TDP-225 continuously feeding labels?
If your TSC Barcode Reader is continuously feeding labels, initialize the printer and perform a gap/black mark calibration.
What does 'Head Open' mean on my TSC Label Maker?
If the TSC Label Maker displays 'Head Open', it means the printer top cover is open. Please close the top cover.
Why is my TSC Label Maker continuously feeding labels?
If your TSC Label Maker is continuously feeding labels, the printer settings may be incorrect. To resolve this, perform the initialization and gap/black mark calibration.
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 DPI |
| Memory | 8 MB Flash |
| Processor | 32-bit RISC |
| Interface | USB 2.0 |
| Power Supply | 100-240V AC, 50/60Hz |
| Operating Temperature | 5°C to 40°C (41°F to 104°F) |
| Storage Temperature | -40°F to 140°F (-20°C to 60°C) |
| Label Width | 60 mm (2.36") |
To Next Page
