TSI Instruments PORTACOUNT 8040 User Manual

54 Chapter 6
For respirators with an outer mesh, install the probe normally
as if the mesh was not present. The sampling probe and push nut
will seal properly right through the mesh.
2. Slide the sampling probe onto the piercing tool. As the pointed
end of the piercing tool is very sharp, be extremely careful
when handling it!
Correct probe location to left
(or right) of valve
Wrong probe location
below (or above) valve

TSI Instruments PORTACOUNT 8040 Specifications

General

Brand	TSI Instruments
Model	PORTACOUNT 8040
Category	Test Equipment
Language	English