UBTECH ADIBOT-A User Manual

User Manual for ADIBOT-A
47 / 50 Shenzhen UBTECH Robotics Corp Ltd.
Part VII FAQs/Troubleshooting
No.
Symptom
Solution
1
ADIBOT-A failed to
start.
◆ Check whether the charging plug on the chassis is loose.
◆ Check whether the power button on the chassis is turned on.
◆ If the problem persists, contact the ADIBOT-A Technical Support
Center.
2
Partial of none of
the UV lamps was
on after the robot
was turned on and a
disinfection
command was sent.
◆ Stop the disinfection task first, and check whether the lamps are
installed properly.
◆ Check whether the full power mode is enabled.
◆ Replace the lamp that cannot light up.
◆ If the problem persists, contact the ADIBOT-A Technical Support
Center.
3
The robot chassis
can not move, or
the motor
overcurrent
protection
◆ Shutdown and restart the robot
4
Bluetooth cannot be
recognized for
pairing.
◆ Make sure that the Bluetooth function is enabled on the tablet PC.
◆ Make sure that the positioning function is enabled on the tablet PC.
5
A WiFi connection
failure prompted
when you tired to
connect to the
internet.
◆ Check whether the WiFi password is correct.
◆ Make sure the robot is close enough to the WiFi device.

UBTECH ADIBOT-A Specifications

General

Brand	UBTECH
Model	ADIBOT-A
Category	Robotics
Language	English