User Manual for ADIBOT-A
49 / 50 Shenzhen UBTECH Robotics Corp Ltd.
Part VIII Declaration of Conformity
7.1 FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the f
ollo wing two conditions: (1) this device may not cause harmful interference, and (2) t
his device must accept any interference received, including interference that may caus
e undesired operation.
Changes or modifications not expressly approved by the party responsible for co
mpliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to prov
ide reasonable protection against harmful interference in a residential installation. Thi
s equipment generates, uses and can radiate radio frequency energy and, if not installe
d and used in accordance with the instructions, may cause harmful interference to radi
o communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the rec
eiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
7.2 FCC Radiation Exposure statement
This equipment complies with FCC radiation exposure limits set forth for an unco
ntrolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator and your body. This transmitter must not be coloc
ated or operating in conjunction with any other antenna or transmitter.
To Next Page
Loading...
Need help?
General
