Safety Precautions in using the device
Connect the probe to the device before toggling the START/STOP switch to START(I)
position. Rest the probe on a non-metallic material (i.e. wooden or plastic chair) when not
in use. Refer to Appendix A on how to connect the probes.
When the START/STOP switch is on the START (I) position, DO NOT touch the probe
connectors while holding the probe loop.
The device is equipped with an overheat sensor to protect the machine in case of an
overheating situation. When overheating occurs, the device will stop pulsing. Let the
device cool down and you may START the device again. If the device is unable to START,
contact your Authorized Distributor’s representative.
After using the device or after toggling the START/STOP switch to STOP (O) position,
allow 5 minutes before toggling the POWER ON/OFF switch to OFF.
When the device is not in use, ALWAYS close the lid to prevent condensation to form.
7
To Next Page
Loading...
Need help?
General
