Quick Start Guide:
Quick guide on how to operate the EPulse Elite
Before beginning of operation:
- Make sure that the green POWER ON/OFF switch is in the OFF position.
- Start/Stop switch is in the STOP(O) position.
- Probe terminals are connected.
- Input voltage power cord is matching (120V) and connected.
- Time is set to 15 minutes (factory default setting)
Power ON Procedure:
1. To the lower right of the panel is the green POWER ON/OFF switch. Flip the switch to the
ON position. The switch should light up.
2. Set the INTENSITY knob to desired setting. Default is at 80%
3. On the upper right of the front panel is the START/STOP switch. Toggle the switch
towards the START(I) position. The switch should light up and the device will start
pulsing.
4. Set the PULSE RATE knob to desired setting. Note that the PULSE RATE knob may turn
beyond 360
o
several times.
Turn the PULSE RATE knob to the RIGHT for SLOWER pulse rate and to the LEFT for
FASTER pulse rate. Note also that turning the knob to the EXTREME position to EITHER
LEFT OR RIGHT will cause the pulsing to stop; putting the device in an “off” state.
Warning: Do not turn the knob far TO THE EXTREME in either direction. Doing so would
cause the knob to break.
8
To Next Page
Loading...
Need help?
General
