Safety Operations
For the safe operation of the device, the following should be observed:
1. Make sure POWER ON/OFF switch is in the OFF [O] position at all times when NOT IN
USE.
2. BEFORE TURNING ON the device, make sure the Probes are connected to the Probe
Connections (Refer to picture below and Appendix A) then rest the probe on a
NON-metallic material. Also, make sure that there are NO metallic objects around the
probe.
3. Plug an AC Cord into the AC Input Power, while making sure that the required input
power of the device (as marked) matches AC line voltage from the wall outlet.
10
To Next Page
Loading...
