UNI-T UT30F User Manual

G.Make Measurements(7)
5. Resistance Measurement (see figure 6)
(figure 6)
1) To avoid damages to the Meter when
measuring resistance, cut off the power
of the object and make sure there is no
charge in capacitor.
2) Test lead wires take 0.1Ω -0.3Ω tolerance
when measuring resistance. To get an
accurate reading, subtract the short circuit
values of the 2 test leads.
3) It will take several seconds for the display
to become stabilized when resistance value
is over 1MΩ.
23
Model UT30B/C/D/F: OPERATING MANUAL

UNI-T UT30F Specifications

General

Brand	UNI-T
Model	UT30F
Category	Multimeter
Language	English