UT3200 Series User Manual
13
WARNING: Make sure test temperature within test line range. UT3208/16/24/32 is
equipped with set of 1/2/3/4
Installation step:
Make sure the power of Instrument is turned off. Please set up as follows,
1. As figure 2-6-1 shown, test line interface face up on same level
2. Insert the test lead in the direction indicated by the arrow of Figure 2-6-1
3. Other channel connect steps is the same
WARNING: The isolation voltage between channels is 350V DC and 230V AC
Figure 2-6-1 Instrument data collect port
Figure 2-6-2 Test line interface
3.3 Channel mark
Instrument is equipped with paster to distinguish different channels which printed
with channel number CH01, CH02 etc. User can past it on different test lines upon
their needs.
Figure 3-4-1 Benchtop Thermometer, take UT3232 as an example
Data acquisition module in the first row on the left, from left to right, correspond to
CH01 CH02 CH03...CH08 channel
Data acquisition module in the second row on the left, from left to right, correspond
to CH09 CH10 CH11...CH16 channel
Data acquisition module in the third row on the left, from left to right, correspond to
CH17 CH10 CH19...CH24 channel
To Next Page
Loading...
Need help?
General
