18
Model UT513: OPERATING MANUAL
To avoid harms to you or damages to the Meter,
please do not attempt to measure voltages
higher than 600V or 600V rms, although
readings may be obtained.
Special care should be taken when measuring
high voltage.
Operating Catuion
To measure voltages, set up the Meter as Figure 4 and
do the following:
Press DCV or ACV button to select DC voltage or
AC voltage measurement
Insert the red and green test lead into the tested
circuit.
When measuring DC voltage, if the red test lead is
negative voltage, ì-ì symbol will show on the display.
1.
2.
3.
When voltage measurement has been completed,
disconnect the connection between the testing
leads and the circuit under test and remove testing
leads away from the input terminals of the Meter.
Note
To Next Page
Loading...
Need help?
General
