Maintenance (2)
B. Testing the Fuses
Warning
To avoid electrical shock or personal injury, remove
the test leads and any input signals before replacing
the battery or fuse.
To prevent damage or injury, install ONLY replacement
fuses with identical amperage, voltage, and speed
ratings.
To test the fuse:
1. Set the rotary switch to
and select by
pressing
.
2. Plug a test lead into the terminal
V Hz and touch
the probe tip to the 10A or mA terminal.
l If the Meter beeps, the fuse is good.
l If the display shows
, replace the fuse and test
again.
l If the display shows any other value, have the
Meter serviced and contact your dealer
immediately.
If the Meter does not work while the fuse is all right, send
it to your dealer for repair.
Model UT70C: OPERATING MANUAL
42
To Next Page
Loading...
Need help?
General
