UTD2000 Series User Manual
59
Chapter XIV Technical Information
Except for those specifications marked with “Typical”, all specifications have warranties.
Unless otherwise specified, all technical specifications are applicable to the probes with
attenuation switch set as 10× as well as UTD2000 series DSO. DSO must first meet the
following two conditions to meet those specification standards:
The instrument must continuously operate for over half an hour within the operating
temperature.
If the change scope of operating temperature is or exceeds 5°C , please perform the
“Self-Adjustment” function in the UTILITY system function.
Acquire System Specification
When the sampling times of all channels are N, N can be chosen among 2, 4, 8, 16, 32, 64, 128
and 256
Input Channel Specifications
Probe attenuation
coefficient
0.01×/0.02×/0.05×/0.1×/0.2×/0.5×/1×/2×/5×/10×/20×/50×/100×/200×/500×/1000×
400Vpk, the transient over voltage is 1000 Vpk.
Horizontal System Specification
Single channel: 64k；Double channel: 32k
Sampling rate and
delay time
accuracy
±50ppm (any time interval ≥1ms )
To Next Page
Loading...
Need help?
General
