UNI-T UTL8500 Series User Manual

UTL8500 Series User Manual
45
Delay On
0~9999s
Set the Start Time of Delay
Short Time
0.1~99999ms
Set the Time for Short Circuit
Test
V Limit
0~150V
Set the Voltage Value of Over-
Voltage Protection
I Limit
0~30A
Set the Current Value of Over-
Current Protection
P Limit
0~150W
Set the Power Value of Over-
Power Protection
V on
0~150V
Set the Load Voltage at the
Beginning of Each Run
V off
0~150V
Set the Low Voltage to
Automatically End Loading
V Trigger
0~150V
Set the Self-Start Voltage of
the List Mode
OVP
ON/OFF
Set whether to Enable the
Overvoltage Protection
Function
Digit Filt
LV1/LV2/LV3/LV4
Set the Level of Digital Filter
Trig Select
Trig/On/Off
Set the Role of External
Trigger Signal Input (Function
Multiplexing)
5.2.1 Run Time
If you set the single load time of the electronic load, no matter what mode it is running in,
the load will automatically stop loading after the set timing is reached. When this function
is not needed, set the parameter to 0.
5.2.2 Delay On
If you set the delay before the electronic load is loaded each time, no matter what mode it
is running, when the ON button is pressed, the electronic load will wait for the set delay
time and then start loading.
5.2.3 V Trigger
V Trigger is the voltage value of automatically-started loading after setting the list mode.
After setting the self-start voltage, enter the list mode without pressing the ON key to enable
the load. When the input voltage of the electronic load exceeds the set self-start voltage,
the list mode will automatically start.

UNI-T UTL8500 Series Specifications

General

Brand	UNI-T
Model	UTL8500 Series
Category	Measuring Instruments
Language	English