Unic Rumba User Manual

- 7 -
6. PROGRAMING OF THE DIFFERENT COFFEE QUANTITIES IN THE CUP
P1 P2 P3 P4
P5
The keys from P1 à P4 can be programmed.
The multiple doses (1 , 2 ou 3 cups ) are calculated automatically from the programming of one
of them on each box.
1
Set the machine switch to Position 0.
2
Keep the key P5 pressed and put again the machine on.
Display of Pn then Pc and Pr by pressing several times the key P5
Pc = CALCULATED PROGRAMMING
Insert a filter-holder ( with coffee ) into the unit
Install cups
" P5
Display Pc
" P1 à P4
Select the dose to be programed (2c for example)
" P5
Start the infusion cycle
" P5
Press again to stop when the amount of coffee desired is correct.
Display of the corresponding digital value ( from 00 à 99 )
3
Repeat operation at 3 for the other doses ( 2C for example)
Pn = DIGITAL PROGRAMMING
Quick programming without coffee and/or values carried foward on other units.
" P5
Display Pn
" P1 à P4
Select the dose to be programed
" P5
Dispaly of the digital value of the selected dose
" P1
Increase the value
" P4
Reduce the value
ε P5
Memorize the new value
4
Repeat operation at 4 for the other doses
5
Pr = MANUAL PROGRAMMING
Same proceeding as in calculated programming Pc.
The manual programming doesn't calculate the other doses (1, 2 or 3 cups), only the
programed dose is modified.
Caution: any new programming ( Pn or Pc ) cancel ALL previous programed
values.
6
Wait until the program mode is automatically inactivated (from 10 to 15s), or switch
off and on again the machine.

Unic Rumba Specifications

General

Brand	Unic
Model	Rumba
Category	Coffee Maker
Language	English