9
© 2015 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd
2.2 Loop of Programming
The philosophy of programming parameters has been shown on the flow chart
of 2.1. Basically user should :
1. Scan Start of Configuration.
2. Scan all necessary labels for parameters that meet applications.
3. Scan End of Configuration to end the programming.
4. To permanently save the settings you programmed, just scan label for
Save Parameters.
5. To go back to the Default Settings, just scan label for Set All Defaults.
( Please refer to 2.4 – Main Page of Configuration)
2.3 Factory Default Settings
The barcode with an asterisk (*) which appears in the following chapters
indicates that it is the default option for the corresponding setting.
You can make your own settings by following the procedures in this manual. If
you want to save the settings permanently, you should scan the label of “Save
Parameters” in chapter 2.4, otherwise the settings will not be saved after the
decoder power is off, and all settings will go back to previous settings.
By scanning “Set All Default” label, the settings will go back to the factory
default settings. ( Please refer to 2.4 – Main Page of Configuration)
To Next Page
Loading...
Need help?
General
