19
© 2015 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd
3.7 Matrix 25 Parameters
A. Check Digit Transmission
Do Not Calculate Check Digit *
Calculate Check Digit & Transmit
Calculate Check Digit & Not Transmit
B. Set Up Code Length
To set the fixed length:
1. Scan the “Begin“ label of the desired set.
2. Go to Numeric Bar Codes in Appendix A, scan label(s) that represents the length to be read.
3. Scan the “Complete“ label of the desired set. Repeat the steps 1 - 3 to set additional lengths.
Variable *
Fix Length (2 Sets Available)
1. 1
ST
Set Begin 3. 1
ST
Set Complete
1. 2
nd
Set Begin 3. 2
nd
Set Complete
Minimum Length
1. Begin 3. Complete
2. Numeric Bar
Codes (Appendix A)
2. Numeric Bar
Codes (Appendix A)
2. Numeric Bar
Codes (Appendix A)
To Next Page
Loading...
Need help?
General
