-67- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS652 User’s Manual
3.8 Codabar (NW - 7)
Scan one of the following bar codes to enable or disable Codabar.
3.8.1 Set Lengths for Codabar
The length of a code refers to the number of characters (i.e., human
readable characters), including check digit(s) the code contains. Set
lengths for Codabar to any length, one or two discrete lengths, or lengths
within a specific range. The default is Length Within Range: 5 to 55.
Note: When setting lengths, enter a leading zero for single digit numbers.
Scan one of the following bar codes to select a length option:
• One Discrete Length - Decode only Codabar symbols containing a
selected length. Select the length using the bar
codes in Appendix B, Numeric Bar Codes. For
example, to decode only Codabar symbols with
14 characters, scan Codabar - One Discrete
Length, and then scan 1, 4. To correct an error or
change the selection, scan Cancel.
• Two Discrete Lengths - Decode only Codabar symbols containing either
of two lengths. Select lengths using the bar
codes in Appendix B, Numeric Bar Codes. For
example, to decode only Codabar symbols
containing either 2 or 14 characters, scan
Codabar - Two Discrete Lengths, and then scan
0, 2, 1, 4. To correct an error or change the
Enable Codabar*
Disable Codabar
To Next Page
Loading...
Need help?
General
