-71- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS652 User’s Manual
3.9 MSI
Scan one of the following bar codes to enable or disable MSI.
3.9.1 Set Lengths for MSI
The length of a code refers to the number of characters (i.e., human
readable characters), including check digit(s) the code contains. Set
lengths for MSI to any length, one or two discrete lengths, or lengths within
a specific range. The default is Length Within Range: 4 to 55.
Note: When setting lengths, enter a leading zero for single digit numbers.
Scan one of the following bar codes to select a length option:
• One Discrete Length - Decode only MSI symbols containing a selected
length. Select the length using the bar codes in
Appendix B, Numeric Bar Codes. For example, to
decode only MSI symbols with 14 characters,
scan MSI - One Discrete Length, and then scan 1,
4. To correct an error or change the selection,
scan Cancel.
• Two Discrete Lengths - Decode only MSI symbols containing either of two
lengths. Select lengths using the bar codes in
Appendix B, Numeric Bar Codes. For example,
to decode only MSI symbols containing either 2
or 14 characters, scan MSI - Two Discrete
Lengths, and then scan 0, 2, 1, 4. To correct an
error or change the selection, scan Cancel.
Enable MSI
Disable MSI *
To Next Page
Loading...
Need help?
General
