-15- © 2019 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS851 User’s Manual
2.10 Prefix / Suffix
2.10.1 Prefix/Suffix Values
A prefix and/or one or two suffixes can be appended to scan data for use in
data editing. To set these values, scan a four-digit number (i.e. four bar codes)
that corresponds to ASCII values. See the Table 2-1 and Numeric Bar Codes
on Appendix B. To change the selection or cancel an incorrect entry, scan
Cancel on Appendix B. To set the Prefix/Suffix values via serial commands,
see Setting Prefixes and Suffixes Via Serial Commands.
NOTE
In order to use Prefix/Suffix values, Data Transmission Format must be set.