Unitech MS851 User Manual

-47- © 2019 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS851 User’s Manual
3.4 Code 93
3.4.1 Code 93
To enable or disable Code 93, scan the appropriate bar code below.
3.4.2 Set Lengths for Code 93
The length of a code refers to the number of characters (i.e., human readable
characters), including check digit(s) the code contains. Lengths for Code 93
may be set for any length, one or two discrete lengths, or lengths within a
specific range. To set lengths via serial commands, see Setting Code Lengths
Via Serial Commands.
One Discrete Length - Select this option to decode only those codes
containing a selected length. For example, select Code 93 One Discrete
Length, then scan 1, 4, to limit the decoding to only Code 93 symbols
containing 14 characters. Numeric bar codes begin on Appendix B. To change
the selection or cancel an incorrect entry, scan Cancel on Appendix B.

Unitech MS851 Specifications

General

Brand	Unitech
Model	MS851
Category	Scanner
Language	English