10
siren will stop and the system disarmed
Note: If you use password pin code to doubl e protect the vehicle security, you will need to
use it to completely disarm the system.
N. SYSTEM’S TRIGGER CHECK (For two-way transceiver operation only)
Press and hold
F button of LCD remote until 3 beeps sound , release and re-press F
button again, the LCD remote will show
“ALARM ”icon flash on text area (see
advanced users mode), then press button to activate system trigger check.
Note: If the system has no response then you are out of range.
O. SYSTEM’S STATUS CHECK (For two-way transceiver operation only)
Press
F button of LCD remote until 3 beeps sound , the LCD remote will show
“STATUS” icon flashing in the text area (see advanced users mode), then press
button to activate system status check .It responds with one melody sound and all
vehicles’ status records will immediately displayed on the LCD screen.
Note: If it has no response then you are out of range.
P. DRIVER PAGING / LOST & FOUND (For two-way transceiver operation only)
This feature is useful the event that someone wants to page the driver of the parked
vehicle or someone can not find his LCD remote transceiver.
Under the ignition switch “OFF” condition, press and hold the valet switch for 5 seconds
to page the driver, one chirp sound shall be emitted from the vehicle and the paging
melody sound continues sounding from the Remote LCD transceiver.
Q. DOME LIGHT CONVENIENCE SUPERVISION (Optional Feature)
The alarm has a unique feature that will turn on your vehicle dome light as follows:
1.Upon disarming, the interior light will remain on for 30 seconds.
2.If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turning on the ignition switch or arming the alarm will turn off the dome light.
R. IGNITION CONTROL DOOR LOCK/UNLOCK. (Programmable Feature)
If the vehicles door locks have been interfaced to the security system, the system will
automatically lock the vehicle's doors when the ignition is turned “ON” and /or unlock
the vehicle’s doors when the ignition is turned “OFF”. (Default setting is “OFF”)
S. TRUNK RELEASE (CHANNEL 3) OUTPUT.
To Next Page
Loading...
Need help?
General
