11
Press and hold button on the transmitter for two seconds to remote control the trunk
release.
T. CHANNEL 4 TIMER CONTROL OUTPUT.
Press the transmitter and buttons at the same time to acti ve Channel 4 function.
Or Press and hold
F button of LCD remote until 2 beeps sound , release and re-press F
button the LCD remote will show “CH 4” icon flash, then press button to activate
channel 4 function.
Channel 4 is user-programmable timer output. You may program the built-in timer to
send a ground signal for any time duration from 1 second to 120 seconds. For instance,
this timer output may be used to turn on the headlight, power window or sunroof.
(Factory defaults setting at momentary output.)
U. POWER SAVER MODE (Default OFF) * See advanced user mode
Under Menu mode press button while “POWER SAVE” icon flash, press button
Power save ON, while the power save mode, the LCD remote transceiver use “0”
current to save the battery power. Press
button Power save OFF
Exit: Press any button of the LCD remote transmitter to exit “Power Save Mode”.
V. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember its
alarm state if the power is lost and then reconnected.
W. SECOND VEHICLE SECURITY OPERATION:
Your 5-button remote transmitter can be utilized to control a second vehicles security
system, To program the remote control transmitter to a second vehicle, follow the
instructions for Transmitter programming.
* For the standard transmitter ( II) is shift button.
Standard Transmitter
1. Prior to pushing any button on the transmitter. Press the Select II button first on the
transmitter.
2. Once II button is pressed the LED on the transmitter will illuminate for 3 seconds to
indicate the second transmitter pin code has built-in.
3. While the LED is illuminated, press any button on the remote control transmitter to
control a second vehicle security system.
For LCD trans ceiver – 2
nd
car operation :
To Next Page
Loading...
Need help?
General
