15
feature.The parking light will flash (1) times. The siren chirps (1) times. The vehicle is now
programmed to start at the same time of the next day. Your set time for the next day
engine start flashes for approx. 3 seconds on the LCD screen. After 3 seconds
icon
stays displayed on the LCD screen.
4. Please insure that you fully understand this feature before programming the
timer start mode.
F. TEMPERATURE CHECK
With the built in temperature sensor you can monitor, Through the LCD screen, the
present indoor temperature of the passenger compartment of your vehicle.
Press and hold the transmitter “
F” button first until 3 chirps are heard. Then press the F
Button three more times so that TEMP appears on the remote. Within 3 seconds press
button; the in-door temperature will be shown on the LCD screen. This reading may
be higher than actual ambient temperature due to the greenhouse effect and is relative
only to the inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press
button once on the remote transmitter under the remote start mode.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to indicate the engine has
stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not
start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The parking (hand) brake is released (For Turbo Timer Mode)
4. Engine is over-revved. {“Tachometer checking type” only}
5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
6. Press
button on the remote transmitter under remote start mode.
7. The system trigger.
8. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM: (If installed)
To Next Page
Loading...
Need help?
General
