UNITY LAUNDRY SYSTEMS UTS40 User Manual

7
Part. 14000001 Rev. 04//2021 ®/™ ©2021 Unity Laundry Systems. All rights reserved.
22. DO NOT reach and/or climb into the tub or onto the washer, ESPECIALLY if the wash drum is moving. This is an
hazardous situation that, if not avoided, will cause severe personal injury or death.
23. All installations required for the proper operation of the machine MUST be carried out in section 3 and in strict compliance
with the legal regulations applicable in the country or jurisdiction of use.
24.Avoidcarryingoutanyactiononthemachinewithouthavingrstreadandunderstoodthemachine’sUserManual,paying
special attention to the Safety Instructions.
25. Carrying out transport, installation, inspection routines, adjustments, maintenance, repairs, cleaning or any work on the
machines without applying safety measures or having the necessary technical know-how can lead to ELECTRICAL
SHOCK OR SERIOUS ACCIDENTS.
26.Whentoolsdesignedforspecictransport,installation,maintenanceandrepairroutinesareavailable,theiruseis
compulsory in order to avoid unnecessary risks.
27. BEFORE CARRYING OUT ANY inspection routine, adjustment, maintenance, repairs, cleaning or any work on the
machine, DISCONNECT IT FROM ALL THE ENERGY SOURCES.
• COMPLETELY disconnect the machine from the power supply and prevent the possibility of accidental reconnection by
performing proper lockout tagout on the external switch and/or the switch breaker. Stopping the machine with the NORMAL
STOP key, emergency stop, or push-button is not enough.
• Disconnect the electrical connection of any circuit external to the machine; for example, external dosing equipment,
external vending units, folders or ironer feeders. These circuits are independent of the supply to the machine.
•Beforebeginninganyprocedurewaitforatleastveminutesaftertheelectricaldisconnection,toeliminateriskofresidual
voltage.
• Close and mechanically lock the manual supply valves.
• Check that the water has COMPLETELY drained, that no part of the machine is at an excessively high temperature and
that no parts are in movement through inertia.
28. DANGER! Some fault localization procedures require checking at different points of the electric circuit with the machine
connected to the power supply and other supply sources. When carrying out these procedures, respect the following
instructions:
• The appropriate checks must be carried out by ONLY ONE PERSON.
• Follow proper guidelines as set fourth by OSHA.
• During these procedures, ONLY remove the protective covers from the electric circuit and/or the inverter. Never remove
the covers protecting the moving parts of the machine.
29. Before the washer is removed from service or discarded, remove the door to the washing compartment.
30.Failuretoinstall,maintain,and/oroperatethiswasheraccordingtothemanufacturer’sinstructionsmayresultinconditions
which can produce bodily injury and/or property damage.
31. THE MANUFACTURER ACCEPTS NO RESPONSIBILITY IF THESE SAFETY INSTRUCTIONS AND ALL THE
INFORMATION IN THE CORRESPONDING MANUALS ARE NOT FOLLOWED. KEEP THESE INSTRUCTIONS IN A
SAFE PLACE.
NOTE: The WARNINGS and IMPORTANT SAFETY INSTRUCTIONS appearing in this manual are not meant to cover
all possible conditions and situations that may occur. Common sense, caution and care must be exercised when
installing, maintaining, or operating the washer.
SAFETY INFORMATION
SAFETY INFORMATION

UNITY LAUNDRY SYSTEMS UTS40 Specifications

General

Brand	UNITY LAUNDRY SYSTEMS
Model	UTS40
Category	Laundry Appliance
Language	English