33
MX-350
ID # - Setting Base Station Address
When you are installing a system withing 100 feet of another equip-
ment location in the same home OR a home, condo, yacht or motor
home that might potentially have an RF remote control of any kind, it is
recommended that you use an addressable base station and set the
address as described here.
You can operate up to 15 different equipment locations, each with an
MRF-200 or MRF-300 assigned a unique Receiver ID#. You program
each or all of your Osiris devices to the appropriate equipment location
by assigning the corresponding ID# in the RF Settings Menus.
From the RF Settings Menu, select ID#.
Decide whether you are changing the ID# for all devices or just one
of the devices of the Osiris.
Select ALL to change the ID# for ALL devices
in the Osiris. Then, go to Step 4.
Select DEVIC to change the ID# for just one of
the devices in the Osiris. Then, go to Step 3.
The display changes to a list of the names of your devices. If you have
two pages of devices, pressing either of the page buttons will display
the other page. Select the device you would like to change the ID#,
then go to Step 4.
1
2
3
ID #
ALL
DEVIC
EXIT
SELECT
ID #
TV
CABLE
DVD
VCR
AUDIO
SELECT
Select a device
Page
Buttons
display the
other page
of devices.
To Next Page
Loading...
Need help?
General
