Universal Remote Control R7 User Manual

AUX Function: Programming a 7th Component
After vou've finished customizing the R7's basic programming for six
primarv components and vou did not use AUX, vou can take
advantage of the AUX function to program a 7th component, such as
a second VCR, DVD, or any other audio/video component that you
may have in your system. It’s very simple. Here’s how:
STEP 1: Turn on the component you want to program.
STEP 2: Refer to the pre-programmed code tables on page 34 and
write down the code numbers listed for your component. The code
numbers are listed by categories of devices, then by brand. See
page 33 for a category list.
STEP 3: Press down both the AUX button and the SELECT (SEL)
button at the same time and hold them down for 3 seconds until the
AUX LED light turns on.
IMPORTANT: If you don't press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and you will need
to start over.
GDOCL
AUX
Button
SELECT
Button
23

Universal Remote Control R7 Specifications

General

Brand	Universal Remote Control
Model	R7
Category	Remote Control
Language	English