Connecting stacked appliances (MAXI.Link)
Connecting appliance with RJ45 cable
1
2
3
RJ45
4
5
6
RJ45
All ChefTop and BakerTop ovens are factory prepared
WR EH FRQQHFWHG WRJHWKHU RU WR DFFHVVRULHV SURYHU
KRRGEODVWFKLOOHU RVPRVLV V\VWHP HWF The acces-
sories connect to the oven by means of RJ45 con-
nectors located on the back of the ovens, which
automatically connect.
n Disconnect all appliances from the electricity mains.
o Remove the rear panel to access the power board.
p Use a cutter to make a vertical slit in one of the rub-
ber caps on the panel behind the oven
q Thread one end of the RJ45 cable through the slot.
r
Insert the end of the cable into the corresponding
IHPDOHFRQQHFWRURQWKHSRZHU3&%LWGRHVQRW
PDWWHUZKLFKRIWKHWKUHHFRQQHFWRUVLVXVHG
s Replace the protective cover and tighten the screws.
t Reconnect all the appliances to the electricity mains.
Follow the instructions of the accessory packing
for information on how to install and manage
them.
Setting ovens as “MASTER” or “CONTROLLED”
MASTER
CONTROLLED
OVEN 1
RJ45
RJ45
RJ45
When dealing with more than one UNOX oven, for
sake or practicality it is best to set one oven as main
0$67(5DQGWKHRWKHUVWRDPD[LPXPRIDVDX[LO-
LDU\&21752//('
All "CONTROLLED" ovens and connected add-ons
LHKRRGSURYHUUHYHUVHRVPRVLVNLWHWFVHH“
Table
E”
FDQEHPDQDJHGIURPWKH0$67(5RYHQFRQWURO
panel.
The EFFICIENT.Power technology cuts the baking sta-
tion's power consumption of up to 33% by better ex-
ploiting distribution of electrical power.
7KHVWDQGDUGRYHQVDUHFRQILJXUHGDV´0$67(5µ
0DLQWDLQ WKH RYHQV LQGHSHQGHQW DOO0$67(5
by not executing the following configuration and
by not connecting them with the RJ45 cable. The ovens
will not function if they are connected with the network
FDEOHZLWKRXWH[HFXWLQJWKHVHWWLQJSURFHGXUHPHVVDJ
e
´12$16µQRDQVZHURQWKHVFUHHQ
English
40
To Next Page
Loading...
Need help?
General