Electrical connections
Before installing the appliance carefully read chapter “
Safety regulations“
at page
5
.
Connections to the power main and the electrical system must comply with the regulations in force
in the country of installation of the appliance; and all connections must be performed by qualified
installer authorised by UNOX.
Failure to comply with these regulations may cause damage and inju-
ries, invalidates the guarantee and relieves UNOX of all liabilities.
LI2293A0 - Printed: 06-2012
Subject to technical changes.
U
N
OX
S.p.
A
.
V
i
a M
aj
o
r
ana
, 22
- 3
5
010 -
Cadon
e
ghe
(P
D
) -
Ital
y
T
e
l
.:
+
39 049 8
6.5
7.511 - F
ax: +39
049 86.
57.55
5
in
fo
@
u
n
ox
.
co
m
ww
w.
u
n
ox
.
co
m
XBC
Electrical connections should be performed by mounting a
SRZHU SOXJ QRW VXSSOLHG RI W\SH DQG ORDG DGHTXDWH WR WKH
maximum power absorbed by the oven's phases
A
GDWD
DYDLODEOH RQ WKH DWWDFKHG ´7HFKQLFDO VSHFLILFDWLRQVµ VKHHW ,I
this is not possible, the wiring cables supplied by UNOX are
sufficient for direct connection to the electrical board
B
.
Before connecting the appliance to the electricity mains, al-
ways compare the power supply data with that of the appli-
ance specified on the rating plate.
The appliance has its power cable already factory mounted to
the terminal board; for different power and voltage require-
ments consult chapter
Adapting to different voltage
at
page
27
.
Oven having only a single-phase Schuco plug may not undergo
any other type of electrical connection and no dimensional
modification of the cable other than extensions, replacing it
only with one having specifications equal to the original fac-
WRU\FDEOHW\SHRIUXEEHUFURVVVHFWLRQHWFDOOVSHFLILFD-
tions are listed on the "Technical Specifications" sheet attached
to the appliance.
B
A
THERMAL + MAGNETO-THERMAL BREAKER
OMNIPOLAR CIRCUIT
BREAKER
The wiring diagrams, the wire specifications and
WKHWHFKQLFDOGDWDDUHLQGLFDWHGRQWKH´7HFKQLFDO
VSHFLILFDWLRQVµVKHHWDWWDFKHGWRWKHDSSOLDQFH
English
26
To Next Page
Loading...
Need help?
General