EasyManuals Logo
Home>UV Dynamics>Accessories>8.40C

UV Dynamics 8.40C User Manual

UV Dynamics 8.40C
11 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
This Class A system conforms to NSF/ANSI 55 for the
disinfection of microbiologically contaminated water
that meets all other public health standards. The
system is not intended to convert wastewater or raw
sewage to drinking water. The system is intended to
be installed on visually clear water.
NSF/ANSI 55 defines wastewater to include human
and / or animal body waste, toilet paper, and any other
material intended to be deposited in a receptacle
designed to receive urine and / or feces (blackwaste);
and other waste materials deposited in plumbing
fixtures (grey waste).
If this system is used for treatment of untreated
surface waters or ground water under the direct
influence of surface water, a device found to be in
conformance for cyst reduction under the appropriate
NSF/ANSI standard shall be installed upstream of the
system.
Warranty
UV Dynamics water disinfection systems are supported with a ‘free from
defects’ Workmanship and Material warranty as follows:
-A ten year pro-rated warranty on the stainless steel disinfection chamber
-A three year warranty on the UV power source
-A one year warranty on UV lamps, sleeves and sensor
-Warranty commences from date of purchase. Proof of purchase required
UV Dynamics will repair or replace, at its option, any defective parts covered by
the warranty. Shipping and handling are not included in this warranty.
Parts repaired or replaced under the pro-rated warranty will be covered under
warranty to the end of the original warranty period. This warranty is also subject to
the conditions and limitations outlined under the heading “General Conditions and
Limitations” below.
Warranty for Replacement Lamps and Parts
UV Dynamics warrants replacement lamps, purchased for annual routine
maintenance, and other parts purchased to repair product components that are no
longer covered by the original warranty, to be free from defects in material and
workmanship for a period of one (1) year from the date of purchase. During this
time, UV Dynamics will repair or replace, at its option, a defective replacement lamp
or part free of charge except for shipping and handling charges. The warranty
period on replacement lamps and parts will be verified using date codes and/or
purchase receipts. You will be advised as to whether the defective item needs to
be returned to UV Dynamics for failure analysis.
General Conditions and Limitations
None of the above warranties cover damage caused by improper use or
maintenance, accidents, acts of God, or minor scratches or imperfections that do not
materially impair the operation of the product. The warranties also do not cover
products that are not installed as outlined in the applicable Owner’s manual.
These limited warranties outline the exclusive remedy for all claims based on a
failure or defect in any of these products. They are in lieu of all other warranties
whether written, oral, implied or statutory.
Under no circumstance shall UV Dynamics have any liability for liquidated
damages for collateral, consequential or special damages, or for loss of profits, or
for actual losses or for loss of production or progress of construction, regardless of
the cause of such damages or losses. In any event, UV Dynamics aggregate total
liability shall not exceed the specific product purchase price. The purchaser agrees
to indemnify and hold harmless UV Dynamics from all claims by third parties in
excess of these limitations.
UV Dynamics does not assume any liability for personal injury or property
damage caused by the use or misuse of any of its products. UV Dynamics shall not
in any event be liable for special, incidental, indirect or consequential damages. UV
Dynamics liability shall, in all instances, be limited to replacement of the defective
product or part and this liability will terminate upon expiration of the applicable
warranty period.
SPECIFCATIONS & WARRANTY
note 1 actual flow rates may be up to 12% less due to flow regulator variability
10
WWW.UVDYNAMICS.COM
UVDynamics
a Castle Circuits Inc. Business Group
315 Neptune Crescent
London, Ontario
Canada, N6M 1A9
t 800.667.4629 f 519.452.1701
email sales@uvdynamics.com
Product Specification
8.40C
11.40C
14.40C
20.40C
Maximum rated Flow Rate @
40mj/cm
2
- note 1
8.7 gpm
(32.9lpm)
(1.97m
3
/hr)
11.0 gpm
(41.6lpm)
(2.49m
3
/hr)
14.5 gpm
(54.8lpm)
(3.28m
3
/hr)
20.2 gpm
(76.4lpm)
(4.58m
3
/hr)
Dynamic Flow Regulator
yes
yes
yes
yes
Isolated Solenoid Drive
yes
yes
yes
yes
Cold Spot Fan
TM
yes
yes
yes
yes
Lamp watts
49watts
64watts
84watts
112watts
Total watts
63watts
81watts
103watts
136watts
AC Supply Voltage
120V 47-63Hz
(240V 47-63Hz)
120V 47-63Hz
(240V 47-63Hz)
120V 47-63Hz
(240V 47-63Hz)
120V 47-63Hz
(240V 47-63Hz)
Annual Lamp Change Timer
yes
yes
yes
yes
Lamp Change Grace Period
28 days maximum
28 days maximum
28 days maximum
28 days maximum
Grace Period Audio Alarm Disable
yes (7day increments)
yes (7day increments)
yes (7day increments)
yes (7day increments)
Reactor Chamber Material
304 SS
304SS
304SS
304SS
Operating Pressure Range
15psi (103kPa) -100psi
(689kPa)
15psi (103kPa) -100psi
(689kPa)
15psi (103kPa) -100psi
(689kPa)
15psi (103kPa) -100psi
(689kPa)
Ambient Temperature
15 - 40C (60 - 104F)
15 - 40C (60 - 104F)
15 - 40C (60 - 104F)
15 - 40C (60 - 104F)
Water Temperature Range
4 25C (40 77F)
4 25C (40 77F)
4 25C (40 77F)
4 25C (40 77F)
Lamp Service Life
9000hrs
9000hrs
9000hrs
9000hrs
Chamber Dimensions (L x D x W)
24.25” x 4” x 6.5”
(61.6 x 10.2 x 16.5cm)
32.5” x 4” x 6.5”
(82.5 x 10.2 x 16.5cm)
39.75” x 4” x 6.5”
(101 x 10.2 x 16.5cm)
50.5” x 4” x 6.5”
(128.3 x 10.2 x 16.5cm)
Chamber diameter
3.5” (8.9cm)
3.5” (8.9cm)
3.5” (8.9cm)
3.5” (8.9cm)
Controller Dimensions (L x D x W)
10” x 1.7” x 2.3”
(25.4 x 4.3 x 5.8cm)
10” x 1.7” x 2.3”
(25.4 x 4.3x5.8cm)
10” x 1.7” x 2.3”
(25.4 x 4.3 x 5.8cm)
10” x 1.7” x 2.3”
(25.4 x 4.3 x 5.8cm)
Shipping Weight
10lbs (5kg)
13lbs (6kg)
14lbs (6.8kg)
17lbs (8.6kg)
Inlet/Outlet Port Size
¾” FNPT inlet
¾”MNPT outlet
1” MNPT inlet
¾” MNPT outlet
1” MNPT inlet
1” MNPT outlet
1’’ MNPT inlet
1” MNPT outlet
© COPYRIGHT 2019 UVDynamics a Castle Circuits Inc. Business Group All RIGHTS RESERVED
System tested and certified by IAPMO
against:
NSF/ANSI 55 Class A
NSF/ANSI 61
NSF/ANSI 372
CSA-B483.1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UV Dynamics 8.40C and is the answer not in the manual?

UV Dynamics 8.40C Specifications

General IconGeneral
BrandUV Dynamics
Model8.40C
CategoryAccessories
LanguageEnglish