(*NOTE: 50ml detergent plus
250ml water to 1 clean water tank).
Operation
Before you begin cleaning
Filling detergent tank
Filling clean water tank
vax.co.uk
5
Remove the detergent
tank from back of unit.
Twist the cap slightly
anti-clockwise to remove.
Pour 50ml of Vax detergent
and 250ml of water using
the measuring jug into the
detergent tank and replace
the tank cap. Tighten by
twisting clockwise.*
Slide detergent tank down
and snap into place.
IMPORTANT: Do not use hot or boiling water to fill clean water tank. Do not overfill the water tank.
NOTE: Do not operate stick steam cleaner without water in the clean water tank.
WARNING: To reduce the risk of personal injury, unplug the stick steam cleaner when filling the unit.
IMPORTANT: Do not mix Vax detergent with any other cleaning detergent.
This product can be used with and without detergent.
WARNING: To reduce the risk of personal injury, unplug the stick steam cleaner when filling the unit.
Remove the clean
water tank at the front
of the unit.
Twist the cap slightly
anti-clockwise to remove.
Fill the tank with max
500ml of water and replace
the water cap. Tighten by
twisting clockwise.
Replace the clean water
tank, clicking into place
making sure the hard water
filter is in place.
NOTE:
Do not
over fill.
IMPORTANT: Your detergent control dial will be set to ‘tough stains’ when you remove your steamer from the
box. If you do not want to use detergent on your flooring, this must be rotated to ‘steam/refreshes carpets only’
position. Always test on an inconspicuous area of flooring first before using detergent.
S2S Series User Guide v1.0_8.0_User guide 23/03/2012 16:25 Page 5
All manuals and user guides at all-guides.com
all-guides.com
To Next Page
Loading...
Need help?
General
