vax.co.uk
11
Steam exhaust vent. Remove cleaning pad and
inspect unit base for
blockages. If a blockage
can be seen use a small
thin object such as a
paper-clip to try to free
blockage.
Maintenance (Keep your Vax as good as new)
Clearing blockages
After steamer use/using cooling base/storage
IMPORTANT: Turn unit off. Allow unit to fully cool down before performing maintenance or
troubleshooting checks.
There is a small opening on the back of the unit at the bottom of the grey trim. This opening is a steam exhaust
vent should the primary path become blocked. If steam starts to escape from this vent you should:
If steam path is still
blocked, remove screw
on floorhead neck.
After floor head is
removed, using a thin
object such as a
paper-clip (in the area
shown), attempt to
remove the blockage.
After using the stick steam cleaner and to avoid damage to your floors, unplug the unit and place stick steam
cleaner on cooling base until product cools. Once cooled, remove steamer pad and follow ‘cleaning the pads’
section. Empty out any remaining water in the tank and clean the external surface with a dry cloth.
S2S Series User Guide v1.0_8.0_User guide 23/03/2012 16:25 Page 11
All manuals and user guides at all-guides.com
To Next Page
Loading...
Need help?
General
