Vax S2 Series User Manual

Operation
Before you begin cleaning
WARNING: To reduce the risk of personal injury, unplug the steam mop when assembling the accessories.
vax.co.uk
5
IMPORTANT: Never use the steam mop without the microfibre cleaning pad correctly attached to the
floor head.
Remove the clean water
tank.
Twist the cap slightly
anti-clockwise to remove.
Fill the tank with max
500ml of water and replace
the water cap, Tighten by
twisting clockwise.
Replace the clean water
tank, clicking into place
making sure the hard water
filter is in place.
IMPORTANT: Do not use hot or boiling water to fill clean water tank. Do not overfill the water tank.
Attaching the cleaning pad
Orange LED will illuminate when the unit is
switched on at the plug and water is heating.
Within approximately 1 minute the Green LED will
also illuminate showing steam mop is ready to use.
The Green LED will go off when unit water is
re-heating.
a
a
b
b
NOTE: Always ensure there is water in the clean water tank.
NOTE:
Do not
over fill.
1
2
Hold corner of pad down with foot
and peel unit away
Undo drawstring.
Remove microfibre cleaning pad.
Velcro microfibre cleaning pad
(dependant on model)
Microfibre cleaning pad
(dependant on model)

Vax S2 Series Specifications

General

Brand	Vax
Model	S2 Series
Category	Steam Cleaner
Language	English