1. Turn ON the device (TV, DVD, VCR, etc.) you wish to program.
2. Refer to the Brand Name Code List. Note the corresponding Number for
the Brand & Device you wish to program. For example to program a RCA
TV the correct number button is “1”
3. Point the remote directly at the remote sensor of your device.
4. Press & Hold at the same time, the Device button (TV, DVD, VCR, etc.)
and the corresponding Number button from step 2 for approximately 2
seconds until the Indicator Light on the POWER button starts to flash
indicating the remote is now in Brand Name Search programming mode.
5. Continue to point the remote at your device while holding the Device
button and the corresponding Number button for your brand until your
device automatically turns OFF.
6. The remote will attempt a new programming code every 2 seconds. Each
time a new code is attempted the Indicator Light will flash.
7. Release all buttons when your device turns OFF. This will save the
successful programming code into the remote’s memory.
8. To confirm if the saved code correctly controls your device, turn the device
back ON and test the other main functions (Volume, Play, Pause, etc.) of
the device with the remote.
• NOTE: Different codes may provide different levels of functionality
for your device. It is important to test a variety of the main functions
of the device (Volume, Play, Pause, Menu, Directional Arrow
Buttons, etc.) to confirm the maximum functionality for your device.
• If the remote is not controlling all of the main functions of the device
repeat steps 1-7 again.
• NOTE: When your device turns OFF for the first time do
not release the Device button & corresponding Number
button. Instead wait until your device turns back ON. This
will indicate another successful code has been found.
MANUAL CODE SEARCH PROGRAMMING
If your device’s brand is not listed in the Code Lists, or if you have tried all of the
codes for your brand and the remote still does not operate your device, try the
Manual Code Search or Automatic Code Search programming methods
described below.
NOTE: The Manual and Automatic Code Search methods cycle through all of the
codes in the Code Lists in the event your device’s code is listed under another
brand. This method may take a long time to find the correct code, therefore if
your brand is listed in the main Code Lists, or the Brand Name Search List first
try the Manual Code Entry or Brand Name Search programming methods to
program your remote.
To Next Page
Loading...
Need help?
General