34
Determine the sequence in which the boilers are star-
ted in order to meet the heat demand.
Tap the following on-screen buttons:
1. If required, for the home screen
2. for the "Main menu"
3. "Boiler sequence"
4. (gas boiler)/ (oil boiler) for the required boiler
5. / for the required position of the selected boiler
in the "Boiler sequence"
6. Repeat steps 4 and 5 for further boilers as
required.
7. to confirm
Naming heating circuits
You can name all heating circuits individually.
Tap the following on-screen buttons:
1. If required, for the home screen
2. for the "Main menu"
3. "Settings"
4. "Rename heating circuits"
5. "Heating circuit 1"
or
"Heating circuit 2"
or
"Heating circuit 3"
6. Using the virtual keyboard, enter the desired name;
e.g. "Ground floor".
Note
deletes the last character entered; discards
the whole entry.
7. to confirm
The name assigned to the relevant "Heating circuit"
appears on the home screen, in the "Main menu"
and, if available, on the remote control display.
Restoring "Factory settings"
You can individually restore all modified values for
each heating circuit to their factory setting.
Settings and values that are reset:
■
Set room temperature
■
Set reduced room temperature
■
Operating program
■
DHW set temperature
■
Time program for central heating
■
Time program for DHW heating
■
Time program for DHW circulation pump
■
Heating curve slope and level
■
Comfort and energy saving functions are disabled
Tap the following on-screen buttons:
1. If required, for the home screen
2. for the "Main menu"
3. "Settings"
4. "Factory settings"
5. "Heating circuit 1"
or
"Heating circuit 2"
or
"Heating circuit 3"
6. to confirm
or
to cancel the operation.
Vitotronic 300: Further system settings
Setting the "Boiler sequence"
5863758
To Next Page
Loading...
Need help?
General
