SPA DRAINING
Every 90 days, depending upon water condition,
you may need to renew the spa water. To drain
your spa, power must be disconnected at the
circuit breaker. Locate the drain faucet inside the
spa cabinet (for Viking IP, 2P & 3 models) or on the
corner near the bottom of the side panel next to the
equipment (for all other models).
1. Twist cap off and attach a garden hose to the
opening.
2. Turn the outside body counter clockwise until it
stops.
3. Pull on the drain that the hose is connected to
until you hear a pop.
4. Drain the spa.
5. Reverse this procedure to shut the water off.
NOTE: The drain will not remove all of the water in the spa.
You may have to remove a small amount of water
by hand.
DRAIN LOCATIONS
MAINTENANCE
Water Gate Valve
Drain for Viking IP, 2P
& Viking 3 Model
Drain for all
other Models
Operation instructions are virtually the same for all of our
models.
17
To Next Page
Loading...
Need help?
General
