TOPSIDE FUNCTIONS
JETS
Press the “Jets” button once to activate the low
speed of the pump and again for the high speed.
Press the “Jets” button again to turn off the pump.
If left running, the low speed of the pump will
automatically turn off after 4 hours, and the high
speed will automatically turn off after 15 minutes.
LIGHT
Press the “Light” button to turn the light on and
off. If left on, the light automatically turns off after
4 hours. In spas equipped with LED light, press
the light button consecutively to change the color
sequenc-ing.
MODE
The mode is changed by pressing the “Temp”
button, then pressing the “Light” button.
Standard Mode is programmed to maintain the
desired temperature. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least 2 minutes. “St”
will be displayed momentarily when you switch into
Standard mode
Economy Mode heats the spa to the set
temperature only during filter cycles. “Ec” will
display solid when temperature is not current, and
will alternate with temperature when temperature is
current.
Sleep Mode heats the spa to within 20°F/10°C
of the set temperature only during filter cycles.
“SL” will display solid when temperature is not
current, and will alternate with temperature when
temperature is current.
Preset Filter Cycles. The first filter cycle begins
6 minutes after the spa is energized. The second
filter cycle begins 12 hours later. Filter duration is
programmable for 2, 4, 6, 8 or (12 hours continuous
filtration, indicated by “FC”). The default filter
time is 2 hours. To program, press “Temp,” then
“Jets.” Press “Temp” to adjust. Press “Jets” to exit
programming.
OPERATION
INSTRUCTIONS
VS100/500
09
To Next Page
Loading...
Need help?
General
